Viewing file:  depca.h (6.68 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/*
Written 1994 by David C. Davies.
Copyright 1994 David C. Davies. This software may be used and distributed
according to the terms of the GNU General Public License, incorporated herein by
reference.
*/
/*
** I/O addresses. Note that the 2k buffer option is not supported in
** this driver.
*/
#define DEPCA_NICSR ioaddr+0x00 /* Network interface CSR */
#define DEPCA_RBI ioaddr+0x02 /* RAM buffer index (2k buffer mode) */
#define DEPCA_DATA ioaddr+0x04 /* LANCE registers' data port */
#define DEPCA_ADDR ioaddr+0x06 /* LANCE registers' address port */
#define DEPCA_HBASE ioaddr+0x08 /* EISA high memory base address reg. */
#define DEPCA_PROM ioaddr+0x0c /* Ethernet address ROM data port */
#define DEPCA_CNFG ioaddr+0x0c /* EISA Configuration port */
#define DEPCA_RBSA ioaddr+0x0e /* RAM buffer starting address (2k buff.) */
/*
** These are LANCE registers addressable through DEPCA_ADDR
*/
#define CSR0 0
#define CSR1 1
#define CSR2 2
#define CSR3 3
/*
** NETWORK INTERFACE CSR (NI_CSR) bit definitions
*/
#define TO 0x0100 /* Time Out for remote boot */
#define SHE 0x0080 /* SHadow memory Enable */
#define BS 0x0040 /* Bank Select */
#define BUF 0x0020 /* BUFfer size (1->32k, 0->64k) */
#define RBE 0x0010 /* Remote Boot Enable (1->net boot) */
#define AAC 0x0008 /* Address ROM Address Counter (1->enable) */
#define _128KB 0x0008 /* 128kB Network RAM (1->enable) */
#define IM 0x0004 /* Interrupt Mask (1->mask) */
#define IEN 0x0002 /* Interrupt tristate ENable (1->enable) */
#define LED 0x0001 /* LED control */
/*
** Control and Status Register 0 (CSR0) bit definitions
*/
#define ERR 0x8000 /* Error summary */
#define BABL 0x4000 /* Babble transmitter timeout error */
#define CERR 0x2000 /* Collision Error */
#define MISS 0x1000 /* Missed packet */
#define MERR 0x0800 /* Memory Error */
#define RINT 0x0400 /* Receiver Interrupt */
#define TINT 0x0200 /* Transmit Interrupt */
#define IDON 0x0100 /* Initialization Done */
#define INTR 0x0080 /* Interrupt Flag */
#define INEA 0x0040 /* Interrupt Enable */
#define RXON 0x0020 /* Receiver on */
#define TXON 0x0010 /* Transmitter on */
#define TDMD 0x0008 /* Transmit Demand */
#define STOP 0x0004 /* Stop */
#define STRT 0x0002 /* Start */
#define INIT 0x0001 /* Initialize */
#define INTM 0xff00 /* Interrupt Mask */
#define INTE 0xfff0 /* Interrupt Enable */
/*
** CONTROL AND STATUS REGISTER 3 (CSR3)
*/
#define BSWP 0x0004 /* Byte SWaP */
#define ACON 0x0002 /* ALE control */
#define BCON 0x0001 /* Byte CONtrol */
/*
** Initialization Block Mode Register
*/
#define PROM 0x8000 /* Promiscuous Mode */
#define EMBA 0x0080 /* Enable Modified Back-off Algorithm */
#define INTL 0x0040 /* Internal Loopback */
#define DRTY 0x0020 /* Disable Retry */
#define COLL 0x0010 /* Force Collision */
#define DTCR 0x0008 /* Disable Transmit CRC */
#define LOOP 0x0004 /* Loopback */
#define DTX 0x0002 /* Disable the Transmitter */
#define DRX 0x0001 /* Disable the Receiver */
/*
** Receive Message Descriptor 1 (RMD1) bit definitions.
*/
#define R_OWN 0x80000000 /* Owner bit 0 = host, 1 = lance */
#define R_ERR 0x4000 /* Error Summary */
#define R_FRAM 0x2000 /* Framing Error */
#define R_OFLO 0x1000 /* Overflow Error */
#define R_CRC 0x0800 /* CRC Error */
#define R_BUFF 0x0400 /* Buffer Error */
#define R_STP 0x0200 /* Start of Packet */
#define R_ENP 0x0100 /* End of Packet */
/*
** Transmit Message Descriptor 1 (TMD1) bit definitions.
*/
#define T_OWN 0x80000000 /* Owner bit 0 = host, 1 = lance */
#define T_ERR 0x4000 /* Error Summary */
#define T_ADD_FCS 0x2000 /* More the 1 retry needed to Xmit */
#define T_MORE 0x1000 /* >1 retry to transmit packet */
#define T_ONE 0x0800 /* 1 try needed to transmit the packet */
#define T_DEF 0x0400 /* Deferred */
#define T_STP 0x02000000 /* Start of Packet */
#define T_ENP 0x01000000 /* End of Packet */
#define T_FLAGS 0xff000000 /* TX Flags Field */
/*
** Transmit Message Descriptor 3 (TMD3) bit definitions.
*/
#define TMD3_BUFF 0x8000 /* BUFFer error */
#define TMD3_UFLO 0x4000 /* UnderFLOw error */
#define TMD3_RES 0x2000 /* REServed */
#define TMD3_LCOL 0x1000 /* Late COLlision */
#define TMD3_LCAR 0x0800 /* Loss of CARrier */
#define TMD3_RTRY 0x0400 /* ReTRY error */
/*
** EISA configuration Register (CNFG) bit definitions
*/
#define TIMEOUT 0x0100 /* 0:2.5 mins, 1: 30 secs */
#define REMOTE 0x0080 /* Remote Boot Enable -> 1 */
#define IRQ11 0x0040 /* Enable -> 1 */
#define IRQ10 0x0020 /* Enable -> 1 */
#define IRQ9 0x0010 /* Enable -> 1 */
#define IRQ5 0x0008 /* Enable -> 1 */
#define BUFF 0x0004 /* 0: 64kB or 128kB, 1: 32kB */
#define PADR16 0x0002 /* RAM on 64kB boundary */
#define PADR17 0x0001 /* RAM on 128kB boundary */
/*
** Miscellaneous
*/
#define HASH_TABLE_LEN 64 /* Bits */
#define HASH_BITS 0x003f /* 6 LS bits */
#define MASK_INTERRUPTS 1
#define UNMASK_INTERRUPTS 0
#define EISA_EN 0x0001 /* Enable EISA bus buffers */
#define EISA_ID iobase+0x0080 /* ID long word for EISA card */
#define EISA_CTRL iobase+0x0084 /* Control word for EISA card */
/*
** Include the IOCTL stuff
*/
#include <linux/sockios.h>
#define DEPCAIOCTL SIOCDEVPRIVATE
struct depca_ioctl {
unsigned short cmd; /* Command to run */
unsigned short len; /* Length of the data buffer */
unsigned char *data; /* Pointer to the data buffer */
};
/*
** Recognised commands for the driver
*/
#define DEPCA_GET_HWADDR 0x01 /* Get the hardware address */
#define DEPCA_SET_HWADDR 0x02 /* Get the hardware address */
#define DEPCA_SET_PROM 0x03 /* Set Promiscuous Mode */
#define DEPCA_CLR_PROM 0x04 /* Clear Promiscuous Mode */
#define DEPCA_SAY_BOO 0x05 /* Say "Boo!" to the kernel log file */
#define DEPCA_GET_MCA 0x06 /* Get a multicast address */
#define DEPCA_SET_MCA 0x07 /* Set a multicast address */
#define DEPCA_CLR_MCA 0x08 /* Clear a multicast address */
#define DEPCA_MCA_EN 0x09 /* Enable a multicast address group */
#define DEPCA_GET_STATS 0x0a /* Get the driver statistics */
#define DEPCA_CLR_STATS 0x0b /* Zero out the driver statistics */
#define DEPCA_GET_REG 0x0c /* Get the Register contents */
#define DEPCA_SET_REG 0x0d /* Set the Register contents */
#define DEPCA_DUMP 0x0f /* Dump the DEPCA Status */
|